spa3102 and traditional phone

[akourou]

hello,

I have setup a configuration with a spa3102 as a pstn gateway, some spa942 as terminals and it all works fine.
I have also setup the analog port of the spa3102 to be able to use a traditional phone as a terminal.
From this traditional phone I can dial to the pstn and to the other terminals but it takes about 10 seconds from the time I finish dialing the number, to make the call.
Note that when I call this traditional phone from the other spa942 terminals, it rings imediately.
Is there a way to reduce this 10second delay?

thank you

 

[galal202]

hello,

I have setup a configuration with a spa3102 as a pstn gateway, some spa942 as terminals and it all works fine.
I have also setup the analog port of the spa3102 to be able to use a traditional phone as a terminal.
From this traditional phone I can dial to the pstn and to the other terminals but it takes about 10 seconds from the time I finish dialing the number, to make the call.
Note that when I call this traditional phone from the other spa942 terminals, it rings imediately.
Is there a way to reduce this 10second delay?

thank you

Hello and welcome,
Modify your dial plan to make it dial directly after last digit

 

[akourou]

Hello and welcome,
Modify your dial plan to make it dial directly after last digit

you mean I have to go to the web interface of the spa3102 and modify a dial plan somewhere there?
if yes, on which page exactly?

thanx

 

[akourou]

Hello and welcome,
Modify your dial plan to make it dial directly after last digit

I modified the dial plan on the Line1 tab of the spa3102.

it was (*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxxxxxxxxx.)

and I changed it to (xx.)

now the time is reduced to 3 seconds

is there a better way or it is ok?

thanx

 

[galal202]

Hello,
no you have to change all the dial plan
it depend on your extensions numbers, outbound rules ..... etc