session border controller

  1. Wake On Lan from 3CX firmware to 3CX SBC

    Since Fanvil use BusyBox as their embedded OS (Not sure about Yealink). It should be possible to make a 3CX firmware that periodically sends WoL packets via the ether-wake command to the SBCs MAC address (Should it not get a registration response from its IP address) to start up the SBC...
  2. SBC (Session Border Controller) - New Equipment

    I have a 3CX system (Version 18) at our main office and 2 remote offices with SBC. The remote offices SBC clients are on equipment I would like to switch out. What is the correct steps to do this and will phones at remote offices automatically use the new SBC? Before I make any changes, I am...
  3. SBC - Session Border Control (On-Prem) - Needed?

    I am still learning our 3CX system I assumed from previous IT staff and there is a site to site VPN setup, but there is an SBC installed at the two remote offices. The ONLY reason he had server equipment at each remote office is to host the SBC, which seems like overkill for what little it is...
  4. Solved 3CX SBC not working after update 3CX PBX to V18

    I have a raspberry pi 4 B8 and am trying to install 3CX SBC on it. However after installation the data must be entered from the SBC trunk but a message keeps coming up that the 3CX server cannot be reached. Have gone through all the steps listed on the 3CX website but it still doesn't work...
  5. SBC Reverse Proxy for PhoneUI

    It would be awesome to get the PhoneUI via Reverse Proxy for phones behind SBC.
  6. One Way Audio with SBC (Session Border Controller)

    Hello, I am experiencing One Way Audio with calls going through a SBC. Initially I had no ports forwarded to the SBC. I have since tried forwarding 5090 without success. The One Way Audio happens when the Phone connected to the SBC dials a number. If I call the Phone connected to the SBC the...
  7. SBC Tunnel ports.

    First time using a hosted PBX. It will have 3 different locations. I've got three raspberry pi's setup as SBCs. Do I need to setup any forwarded ports? They seem to work fine but I don't want to have intermittent problems down the road.
  8. Solved SBC 100% CPU utilisation

    I've noticed since an auto-upgrade to 3CX v15.5.8801.3 that my SBC's CPU utilisation is sitting at 100%. It seems rebooting the 3CX server relieves the load temporarily, however utilisation ramps back up with in a few minutes. I have tried re-installing the SBC, even tried it on a fresh...
  9. GDPR

    Hi, I was wondering about the General Data Protection Regulations (GDPR for short..), lets say i have a PBX setup with a SBC on remote offices, there is NO encryption because we noticed issues on the line. Are we forced by the GDPR to enable the encryption anyway and thus having more issues...
  10. Cannot connect SBC to PBX through pfSense - HELP

    Hello everyone, I'm going crazy with my current issue and need some advice from someone who knows 3cx Session border controllers and pfSense. I have taken over the IT work for 3 sites for the same company: -1 site with 3CX loaded on the file server and behind an Untangle firewall (let's call it...
  11. accentlogic

    IMPLEMENTED: Make Session Border Controllers (SBC) an object in console

    Currently each phone must have the IP address of a chosen SBC manually entered. Please add a list of Session Border Controllers so that these systems can be manually entered (or even automatically populated when an SBC checks in). Ideally, the SBC would have an internal identifier and would...