3CX for Windows auto answers all calls

[hamish.fenn]

Hello All,
I have a Yealink T26P running Firmware Version 6.73.0.50 Hardware Version 4.0.1.44,
in cti mode.
I have noticed that if the 3cx for windows client is running, all calls are autoanswered.
If i shut down the 3cx for windows client everything behaves as expected.
I have searched through everything and there is no autoanswer set anywhere,
I have tried different phones , same result,
It was running ver 12 and i have just upgraded to 12.5, still same.
Is there somewhere I can check why it auto answers?
Any idea what might make it auto answer.
It is consistent, with the 3cx for windows running it autoanswers the line.
Regards,
hamish

 

[craigreilly]

There was mention of this issue on incoming calls after the first one - and this is a CTI Issue - not 3cx specifically.
It sounds similar to this - except it is happening on the first call.