3CX V11 and Patton 4114

[pebble1]

Everything was working and I decided to update the Firmware of the Patton from 4.2 to 6.3. Now I cannot make calls. It shows the trunks registered and I can receive incoming calls fine. When I try placing a call I see 0/1 go active for 15 seconds then it tries 0/1 and on until it fails and gives a busy signal.

The Log shows: "Call or Registration to 8283367688@(Ln.10000@Patton 4114 4xFXO) has failed. [ V4 192.168.50.21:5066 UDP target domain=unspecified mFlowKey=868 ] replied: 502 Bad Gateway; from IP:192.168.50.21:5066"

I did create a new config file and same result.
It worked before upgrade, I tried rolling back to 4.2 but it does not work either.

 

[Kevin Attard Compagno]

@pebble1

The response "502 Bad Gateway" typically means that the POTS line is faulty in some way (maybe not connected). Port number 5066 indicates (typically) the 4th port - is there a line connected to port 4?