3cx with yeaster s300

[mohamed hamed]

Hi,
i have 3cx latest version (windows) and s300 (firmware version) V1.40 0000-0000 , i want to use s300 FXO trunk to make outgoing calls from 3cx.

i tried this steps https://support.yeastar.com/hc/en-u...nnect-3CX-and-Yeastar-S-Series-VoIP-PBX#step1

but it's not working .

can i use Type of Authentication registered account based to create inbound rule in s300 to route to extension instead of route to outgoing rule , if yes how can i do it.

thank you

 

[YiannisH_3CX]

Hi @mohamed hamed

We really cannot advice on how to set this up as we do not support this configuration and was never tested by us. I would recommend adding a supported FXO device to your 3CX to be able to make outbound calls.