Hello,
I know that this question has been already asked in a few other topics, but I'm encountering some issues hooking up my FreeSwitch PBX to the 3CX.
We need to achieve this because we plan to migrate the FreeSwitch to the 3CX, but it's a long term migration and we need the both PBX'es to comunicate between them.
I've created a Master Bridge under 3CX, with extension 10007, I setup the FreeSwitch as in the Youtube tutorial that I found ->
I've followed all the steps and I can't succeed on getting the Bridge registered.
The FreeSwitch it's sending INVITE's for REGISTER, they are received by the 3CX PBX which responds with 407 Proxy Authentication Required, but that's all. The FreeSwitch isn't responding back with something else, and I was wondering if there's something that I'm doing wrong, or is any way to avoid this 407 being sent from the 3CX back to the FreeSwitch.
Both PBX systems are on WAN, without LAN (NAT) IP Addresses attached. Firewall it's set to allow connections from public no matter what.
Here's a PCAP that I run on 3CX PBX. I can see from the SIP Flows that FusionPBX is trying to establish the SIP Connection from port 5080 to port 5060 over 3CX, but there's nothing going back from FusionPBX to the 3CX PBX.
The IP with 194. it's the FusionPBX and the IP with 193. it's the 3CX.
Any help/hints it's greatly appreciated!
I know that this question has been already asked in a few other topics, but I'm encountering some issues hooking up my FreeSwitch PBX to the 3CX.
We need to achieve this because we plan to migrate the FreeSwitch to the 3CX, but it's a long term migration and we need the both PBX'es to comunicate between them.
I've created a Master Bridge under 3CX, with extension 10007, I setup the FreeSwitch as in the Youtube tutorial that I found ->
I've followed all the steps and I can't succeed on getting the Bridge registered.
The FreeSwitch it's sending INVITE's for REGISTER, they are received by the 3CX PBX which responds with 407 Proxy Authentication Required, but that's all. The FreeSwitch isn't responding back with something else, and I was wondering if there's something that I'm doing wrong, or is any way to avoid this 407 being sent from the 3CX back to the FreeSwitch.
Both PBX systems are on WAN, without LAN (NAT) IP Addresses attached. Firewall it's set to allow connections from public no matter what.
Here's a PCAP that I run on 3CX PBX. I can see from the SIP Flows that FusionPBX is trying to establish the SIP Connection from port 5080 to port 5060 over 3CX, but there's nothing going back from FusionPBX to the 3CX PBX.
The IP with 194. it's the FusionPBX and the IP with 193. it's the 3CX.
Any help/hints it's greatly appreciated!
