cannot dial out

[pdq]

New install, outbound rule and PAtton 4114 configuration entered. Inbound calls work fine. I get a fast busy immediasley when I click dial.

Logs:

15:41:23.741 [CM503020]: Normal call termination. Reason: Not found
15:41:23.740 [CM503016]: Call(8): Attempt to reach <sip:[email protected]> failed. Reason: Not Found
15:41:23.739 [CM503014]: Call(8): No known route to target: <sip:[email protected]>
15:41:23.734 [CM503010]: Making route(s) to <sip:[email protected]>
15:41:23.723 [CM505001]: Ext.110: Device info: Device Identified: [Man: Cisco;Mod: SPA Series;Rev: General] Capabilities:[reinvite, replaces, unable-no-sdp, no-recvonly] UserAgent: [Cisco/SPA502G-7.1.3a] PBX contact: [sip:[email protected]:5060]
15:41:23.715 [CM503001]: Call(8): Incoming call from Ext.110 to <sip:[email protected]>
15:38:58.751 [CM503008]: Call(7): Call is terminated
15:38:53.394 Currently active calls - 1: [7]
15:38:44.305 [CM503007]: Call(7): Device joined: sip:[email protected]:5060
15:38:44.296 [CM503007]: Call(7): Device joined: sip:[email protected]:5062
15:38:23.394 Currently active calls - 1: [7]


Frustrated in Florida

 

[pdq]

Frustration fixed due to _____.

 

[mfm]

Not sure what your last post means,. but your logs are telling you that you do not have an outbound rule to satisfy the number being dialed.

 

[pdq]

It means I found the issue in the outbound rule.