Choosing Static Lan Ip address when installing first time

[tecno]

Hi, I have searched for this but find only missunderstanding guide lines...

I want to make a new installation of v16 on a virtual machine wich I want to have a static ip address.ù

If I do the automatic installation the wizard guides me troughout the whole process and then it restarts the machine asking me to choose if I want to configure using web browser or shell. If I choos web browser it sends me to the ip address the network interface got from the dhcp

I have tried to make the expert installation succesfully choosing my ip address but as it went step by step trough the linux installation I don't know if I have set everything ok

I have also tryied to change ip address with ssh succesfully right after the first reboot (before the 3cx wizard) but if I reboot it does not seem to get the ip address and on the screen I see connect to "localhost:5001" etc

Is there a different way to configure 3cx for the first time using a local ip address being sure that the installation is fully set?
Thanks in advance
Regards

 

[cobaltit]

There's a really helpful guide on how to install 3CX located here:
https://www.3cx.com/docs/manual/installing-debian-linux-pbx/

 

[tecno]

thanks @cobaltit this was very helpfull, I just had to press esc to go back to the network config and then hit continue to all the other steps so now I am sure I have done everything ok, this is exactly what I was looking for; Thanks !