default VLan id.

[chrishoneywell]

I have a 3CX version 11.0.28976..... running Microsoft server 2008 SP1.
I have over 200 Grandstream 1400 and 30 Grandstream 1450 phones.
I want to use VLan 1 for my phones and VLan 21 for my computers connected to the PC out on the phones.
I can set VLan 1 on the Layer 2 QoS 802.1Q/VLAN Tag do an apply and save all works well.
When I reboot the phone it gets a new config from the server and defaults back to blank or 0.
Where can I set Vlan 1 for the phone provisioning on the 3CX server?
I am using Trendnet managed 24 port gigabit switches.
Thanks

 

[sunstate]

You are going to need to mofify the Grandstream template so that the phones get the VLAN settings every time they pull the config or a new one is provisioned. However after a quick glance at the stock Grandstream template (not the 3CX template), there doesn't appear to be a VLAN setting for the network ports on the phone, only for tagging the and apply QoS to the RTP.

# Layer 2 QoS. 802.1Q/VLAN Tag (VLAN classification for RTP). Default is 0
# Number: 0 - 4094
# Mandatory
P51 = 0

# Layer 2 QoS. 802.1p priority value (0 - 7). Default is 0
# Number: 0 - 7
# Mandatory
P87 = 0

You'll probably want to take this up with Grandstream. I have attached the default Grandstream template, for our review. I've always assumed these contain all of the available provisioning settings, but I could be wrong.