Has anyone used the Cisco SPA3000

[terrys]

I have a customer who needs to use one POTS line. Has anyone used the Cisco SPA3000 for an FXO??

 

[eddv123]

Others on this forum have been setting these up, and 3CX used to have a manual setup guide dedicated to this device range however it has been removed - as you are probably aware these devices are un-supported.

Either way you will need to set the device up in 3CX as a "Generic" Gateway, select the amount of lines you wish to use and main trunk number and setup the Cisco manually to register to 3CX.

A little more work than a fully supported gateway like a Patton or beroNet but you should be able to achieve it.

 

[sip.bg]

You can configure it manually, it is very similar to SPA-3102 (f you find guides for it). Just create a custom gateway into your 3CX.