Incoming Calls rule DID Sequence is gone in V20?

[Sim4711]

Hello,

I cannot change the sequence of incoming calls DIDs? We used that to block anonymous calls in a rule before the rules for our fax lines. The fax rules was at the end of all rules.

So we are sure, that an anonymous caller will end on the normal phone extensions, but is blocked, if it's a fax call.

Where can i change the sequence? Or it's not planned to do this in phuture?

 

[SweetAction]

v20 does not have caller ID rules, just DID rules.

A workaround would be to have the inbound DID go to a CFD or RoutePoint script, then do the caller ID filtering with that.

 

[Sim4711]

v20 does not have caller ID rules, just DID rules.

A workaround would be to have the inbound DID go to a CFD or RoutePoint script, then do the caller ID filtering with that.

How to do that? But will it then be filtered? e.g. normal calls with Caller ID go to the extension 201 and anonymous calls are blocked?

 

[noord]

How to do that? But will it then be filtered? e.g. normal calls with Caller ID go to the extension 201 and anonymous calls are blocked?

They are back in RC3 again
Go to Admin, Advanced, CID Rules!