ISDN Alarm system connected through Patton DTA - Config help

[rvdsarr]

Hi guys,

I am looking to install an older ISDN alarm system on 3CX. I believe the Patton SmartNode DTA SN-DTA/2BIS2V4HP/EUI is the right device for it, but I have not been able to find good information on how to install all of this.

I hope someone on this forum has the knowledge and is willing to help me configure it start to end. Ofcourse I will make sure to compensate your time spend.

Hope someone gets in touch

Kind regards, Roy

 

[leejor]

Hopefully you'll get a few more replies, than this post a few years ago...

https://www.3cx.com/community/threads/patton-sn-dta-1bis2v-isdn-to-3cx.48871/

Unfortunately, there are not going to be many, that have the time time, to try to get working, an unsupported device. If you haven't yet made the purchase, I would strongly suggest going with a device supported by 3CX .

This is not to say it won't work, with some time and effort, but, I suspect, you may be, for the most part, on your own.

Isn't ISDN BRI just about at it's end of life in many places?