Linksys PAP2T

[wlt7913c]

I am using a Linksys PAP2T device as an extension. I have created an extension and successfully registered Line 2 and can make and receive calls. The problem I have is when I go to create another extension I cannot use the same device because of the MAC address. So how do I register the other line as an extension?

 

[mixig]

PAP2T is ATA right? You can normally configured two extension on that device, if you put mac address of PAP2T under the extension settings remove it, you dont need to put mac address, you are not doing provisioning via 3cx in this case

 

[wlt7913c]

Well it won't let me remove that information, so I will delete the extension, and not provide provisioning information and see what happens... Yep that did the trick, complete brain fart on my end regarding the provisioning. thanks