Luxembour P&T Analogue call via SPA 3102

[Mark3XP]

Failed to setup 3CX to PSTN with P&T Luxembourg so decided to try and get the analogue phone working before routing to 3CX. So I have managed to be able to answer calls but cannot terminate conversation. Cannot make outgoing calls either. I think the reqgional config page and local diconnect tones etc are not correct. Any ideas what these should be or how to find out. Need dial tones, cadence etc for P&T Luxembourg.

If people help and I get this working I shall post the full settings here to help other. Without such settings 3CX is this small country is cimply not going to happen ;-(

Please help.

 

[leejor]

The document for this product lists the dialtone and ring cadence for a number of counties...
http://www.crucible-technologies.co.uk/downloads/duotel_plus_manual.pdf

And there is this..."The modern dial tone varies between countries, being a "buzz" of two interfering tones (350 Hz and 440 Hz, as defined in the Precise Tone Plan) in the NANP (most of North America), and a constant single tone (425 Hz) in most of Europe. " from Wikipedia

So I have managed to be able to answer calls but cannot terminate conversation. Cannot make outgoing calls either.

So you can answer calls coming in through the 3102 or just internally? Post a 3CX log of an attempted outgoing call from the extension.