open ports on Router Dlink Di-604

[jose_chile]

Hi, i install 3cx free on my office, conecting directly the modem with Lan Card of my server, and all work Fine. But i Buy a router Dlink di-604 and now not work. Viewing some forums, and your manual, say that i must open port 5060, 3478 , 5481, 7000-7250, 9000-9250. But if i do that the remote ata dont conect and i can`t see the stun server. If i enable the virtual server of Di-604 and add ports 5060, the remote ata conect but dont make calls.
Do you have some manual for configure Router Dlink DI-604 ???
Thanks
Jose

 

[Mirzab]

D-Link manual at http://www.dlink.ca/product.php?PID=145. If you are asking does 3CX have specific setup info for this Router the answer in no, too many models and methods in the world. I have this model router and have STUN under "Virtual Server" with all other ports under "Firewall". Port range 7000-7250 is for internal use only, not needed on router to the best of my knowledge. Port 5481 only if you wish external access to 3CX admin, as you know.

 

[touficjohn]

Here have a look at this post should shed some light on what ports to open and maybe portforward.com has your router listed

http://www.3cx.com/forums/categories-1/3cx-phone-system-general-1/the-portforwarding-faq-hope-this-gets-a-sticky-1697/?highlight=portforward

 

[ecwilson]

Take a look at this post it worked for us & no port configurations at all.
We are using a linksys router & grandstream phones. I hope this helps

http://www.3cx.com/forums/categories-1/3cx-phone-system-general-1/data-ceter-setup-remote-extension-will-not-ring-2321/

ecwilson