Outbound Rule Question

[gschwab]

I have 3CX version 10 service pack 6 up and running thru a Grandstream 4108 gateway with 4 PSTN lines connected, NO VOIP service. I am using 2 Yealink T38G and 5 T20P phones. Everything is working fine, inbound, outbound, auto attendant. All is well but I can't seem to figure out if it is possible to route certain outbound calls to a specific PORT or channel on the gateway. we have two lines that have unlimited long distance and two that don't so I would like to route all long distance calls from any extension to line (or channel) 3 or 4. Is this even possible with my current setup?
Thanks in advance
George

 

[leejor]

I'm assuming that you have the gateway configured as one trunk group. You would have to split up the existing four members of one group and create a two groups of two trunks, or one of two, and two of one member each.

 

[jpillow]

You can simply set up and outbound rule, and dial like a 9 first before any LD calls. By doing so you can designate those oubound calls to those two ports.

 

[willow]

you will need to set up two trunk groups in the 3cx and the grand stream and then use outbound rules to route accordingly.