Is it possible to have distinct rings for different extensions or ring-groups? I know it was on PBX in a Flash and hope to do that here as well.
---
Details / scenario:
I've got a small home/office. DID #A goes to group #1 and then to extensions E11, E12, etc.
DID #B goes to group #2 and the to extensions E21, E22, etc.
There is no crossover.
In some cases, a phone will cover both. For instance line 1 is E11 and line 2 is E21.
I would like to be able to have a different ring for E11 than for E21.
--
Further details
Some of the phones I'm using are OLD cisco 7940s. I know they are not supported but still work well and can be manually provisioned. I did this formerly by feeding them different bellcore rings.
---
Thanks,
Rylen
---
Details / scenario:
I've got a small home/office. DID #A goes to group #1 and then to extensions E11, E12, etc.
DID #B goes to group #2 and the to extensions E21, E22, etc.
There is no crossover.
In some cases, a phone will cover both. For instance line 1 is E11 and line 2 is E21.
I would like to be able to have a different ring for E11 than for E21.
--
Further details
Some of the phones I'm using are OLD cisco 7940s. I know they are not supported but still work well and can be manually provisioned. I did this formerly by feeding them different bellcore rings.
---
Thanks,
Rylen
