SPA-3102

[George Georgiou]

I Have evrithing working find exept for outbound calls with the Linksys SPA-3102.

Any idea

My setup on 3120 is

Dial Plan 8: (S0<:10000>)
Disconnect Tone: 480@-30,620@-30;4(.25/.25/1+2)

 

[Mirzab]

There have been a lot of SPA3012 config questions and issues recently, quite a lot from me in the total :lol: I did get mine working fine and now love it. PM me with an email address and I will send my configuration screen prints for the SPA and 3CX. Probably the easiest start.

 

[Anonymous]

I Have evrithing working find exept for outbound calls with the Linksys SPA-3102.

Any idea

My setup on 3120 is

Dial Plan 8: (S0<:10000>)
Disconnect Tone: 480@-30,620@-30;4(.25/.25/1+2)

Outbound PSTN or outbount VSP?

 

[George Georgiou]

itfarmer

outbound PSTN

 

[Anonymous]

In the Line 1 Tab
1. Dial plan enter something like <#9:><gw0>. #9 being what you dial to get through to the PSTN. You can use another combination if you like.
2. In the PSTN Tab:
Leave dial plan 1 empty
Make sure VoIP-To-PSTN Gateway Enable is set to “Yes”
Line 1 VoIP Caller DP: “1”
VoIP Caller Auth Method: “PIN”

 

[Mirzab]

Hi George, email sent with screen prints attached. Remember please that my overall setup works for North America so ignore settings that would be country specific. I am also afraid that I use mine somewhat different than most, for example I access in/out directly on the PSTN tab and do not use dial plans or dial from Line 1, so you will find my settings do not conform to most. End result is the same though, it works :lol: