voicemail not working

[scrhill]

hello,

i have setup two extenstions and we have 2 DIDs, when someone calls on either DID. it rings a ringgroup its set if no one answers to goto a certain voicemail box however it goes to the Provider's voicemail system and not the system on 3cx

any ideas?

Rob

also when i provision my phones automatically they fail registration and in the server urls it says ipARAM_not_found

 

[abc123]

Is the provider a pstn provider (e.g. Verizon)?

You would either have to set this to go to the failover voicemail after 25 seconds rather than anything longer as most providers cut in at 30 seconds with their voicemail.

Or have them turn that feature off.

We need more information on the phones, etc to be able to help with the provisioning

 

[sigma1]

Your SIP provider must have a ring timeout on their service, either up that value or disable it (much better). Just use their answering system in the event of a NON-REACHABLE/NOT REGISTERED status (failover).

Looks like a template issue. What phones are you using?

 

[scrhill]

the phones are Grandstream GXP-2000..... they provisioned correctly under my laptop when i was playing with 3CX my laptop is a Intel Celeron 3.2GHz wth 2GB ram and Windows 7 Ultimate.. the Server which its on now is Windows 2003 SP2 R2 with all ports needed open and im using abyss as web server

when it provisions it sets sip and proxy servers to http://192.168.80.11ARAM_not_found

this is the line in the template (which is the same line as the template when i tested 3cx on a win7 laptop)

# The "P47" field contains the ip address and SIP port of the SIP Registrar - in this case 3CXPS. The "pbx_ip" and "param::sipport" variables will be replaced by the IP Address and SIP Port of 3CXPS.
P47 = %%pbx_ip%%:%%param::sipport%%

# The "P48" field contains the ip address and SIP port of the SIP Outbound Proxy - in this case 3CXPS. The "pbx_ip" and "param::sipport" variables will be replaced by the IP Address and SIP Port of 3CXPS.
P48 = %%pbx_ip%%:%%param::sipport%%

 

[sigma1]

What do you have under Advanced ->Custom Parameters -> DefaultLocalIP ?

 

[scrhill]

DEFAULTLOCALIP: 192.168.80.11
SIPPORT: 5060

Thats what it shows in Settings ----- Advanced ----- Custom Parameters