3cx Auto Provisioning T46G

[dangmoss]

This is my 3rd or 4th 3cx install and I have come across an odd problem.

I have the latest 3cx (activated with 8sc).

I have Yealink T46G phones.

All are on the same subnet, same switch actually.

But some odd reason they don't show up under 'phones' so I can just assign them to an extension.

I have tried the latest firmware.

I have tried a different switch.

Fooling around with it and rebooted several different parts at different times has resulted in at best 3 out of 4 phones showing up.

What gives?

 

[805tech]

Have you tried restarting all the services under the Service Status section? Caution if you do restart all the server make sure no one is on a phone call. It will bring down everything until everything is restarted.

 

[dangmoss]

Ya several times
It's a new install

I even tried a new 3cx install on a different pc

I have had some success by downgrading firmware on t46g to the 3cx one they list ends in 228 I think

 

[Jessep]

Have you tried a factory reset on the phones and starting the provisioning process from scratch?

 

[dangmoss]

Yep
31 new phones

 

[Jessep]

I would still factory reset the troublesome phones, something may have gone a little sideways in the initial provisioning attempt.

 

[dangmoss]

Oh I did

Lots and lots

Upgraded and downgraded firmware

Different router
Different switch

Gonna pull my hair out

 

[jpillow]

Why not manually provision?

 

[dangmoss]

ya ofcourse

I would rather not for 31 phones

something isnt right...

looks like downgrading to 228 fixes it