3cx Dial extension along with phone number

Status
Not open for further replies.

vinod700

Joined
Jan 27, 2017
Messages
4
Reaction score
0

How do I add a pause in a dialed number so I can access an extension.
Eg: I am dialing a phone number that may attend by the ivr and need to enter the extension no again.

Regards,
vinod


 
dear vinod700,

If I understand correctly, you want to have the ability to call the main number of a trunk followed by an extension number so you can connect automatically, is that correct?
 
A pause would have to be "created" in the set (speed call number) doing the dialling. In most cases, the first number, before the pause, is sent as a SIP message (and routing of the call done on that), whereas the digits after the pause are generally sent as DTMF (which may be converted to a SIP message along the line). Same way your mobile phone would do it.
 
Last edited:
dear vinod700,

If I understand correctly, you want to have the ability to call the main number of a trunk followed by an extension number so you can connect automatically, is that correct?

Yes. You are correct. Or in which pattern the the extension number can be dialed with
 
A pause would have to be "created" in the set (speed call number) doing the dialling. In most cases, the first number, before the pause, is sent as a SIP message (and routing of the call done on that), whereas the digits after the pause are generally sent as DTMF (which may be converted to a SIP message along the line). Same way your mobile phone would do it.[/ QUOTE]


Hello

can you tell how will be the dial patterns which key / chartecter act as pause
 
dear vinod700,

If I understand correctly, you want to have the ability to call the main number of a trunk followed by an extension number so you can connect automatically, is that correct?

yes . its correct. . can you advice how it can be achived
 
Status
Not open for further replies.

Forum statistics

Threads
111,852
Messages
589,389
Members
164,691
Latest member
Daz1964