Camrivox Flexor 500 Phone

[nigelainscoe]

This is my first foray into IP telephony. I have signed up with sipgate and the 3CX server has registered itself with that OK.

I have bought a Camrivox Flexor 500 Phone as it is well specified and seemed a good buy. Now I am struggling to get it to connect to the 3CX software. Has anyone any experience of using one of these phones

Regards,
Nigel Ainscoe

This is the phone spec if it is any use:
IVoice Algorithms and Protocols

* SIP, RTP, SDP
* UDP, TCP and TLS supported
* VAD - Voice Activity Detect
* CNG - Comfort Noise Generation
* Jitter Buffer - Adaptive
* Packet Loss Compensator
* International Call Progress Tone generator
* DTMF: In-band and Out-of-band (RFC2833)
* Caller ID support (Name and Number)
* Call Waiting Indicator tone
* Message Waiting Indicator tone
* G.711, G.726, G.729

Networking

* DHCP client, DNS client
* ICMP, TCP/UDP/IP
* STUN
* SNTP
* HTTP/HTTPS
* RIP and RIPv2

Quality of Service (QoS)

* 802.1Q
* Type of Service (ToS)
* Pacing and prioritization of voice data
* VLAN (802.1pq)

 

[N_G]

You should use a 3CX supported phone - see our support page for this list.