I finally managed to configure a Zultys 2x1 (2x2) sip phone

[needle]

hi there,

I almost went bananas and lost any hope but unexpectedly this afternoon I had an idea that solved the issue: the phone now works like a charm!!!

I won't bother with details, I will just give the config, I suggest to proceed to a complete factory reset before starting:

1 - go to "Protected Settings" -> "SIP Communications" and set:
the IP of your pbx in "Proxy Address"
"Yes" in "Register with Proxy"
your extension password in "Proxy password"
"1800" in "Registration Expires" and "Subscription Expires"
2 - go to "Protected Settings" -> "Names and Numbers" and set:
your extension # in "Device ID"
the IP of your pbx in "Domain"
the mailbox extension in "Voice Mail"
3 - ENJOY YOUR ZULTYS 2X1 OR 2X2 SIP PHONE!!!

 

[leejor]

Re: I finally managed to configure a Zultys 2x1 (2x2) sip ph

It is unfortunate that some SIP device makers choose to use different terminology for the same data fields. Glad you got it working.

 

[rancho]

Re: I finally managed to configure a Zultys 2x1 (2x2) sip ph

The 2x1 is virtually the same as the 2P of which I have acquired 6 never used devices. I have had no success configuring these either with 3CX or direct to SipGate. I followed these instructions and the phones only work for incoming calls, either from outside or from another extension. When I try to dial out I get the reorder tone and 'error' displayed. It was just the opposite when configuring for SipGate, the phone dials out fine, but nothing happens when I call in.

Like I said I followed these instructions to the tee to no avail. It's time to dump these on ebaY unless anyone can shed some light.
:evil:

 

[rancho]

Re: I finally managed to configure a Zultys 2x1 (2x2) sip ph

I did a little more investigating. Turns out that every time I rebooted the phone, my settings for 'domain' under 'names and numbers' kept getting overwritten. This was due to using DHCP. So I disabled DHCP in the settings, assigned a static IP, reassigned the PBX Ip to 'domain', saved and rebooted. That did the trick. The phone now makes and receives calls flawlessly.

I'm a happy camper now.