Update Latest Firmware on 3cx instead of manually doing it.

[John14]

Hi,

I'm aware of manually updating Yealink firmware through the Yealink interface, but it does take long when you have to update many phones. Is there a way we can readjust the templates to pull the new update or another way? my current phones version is 28.83.0.50, Yealink T46S, latest firmware is 66.84.0.35

 

[cobaltit]

Phones at that firmware level should provision just fine and then you can push the firmware out via 3CX.

 

[Saqqara]

You can select multiply phones, and click on the firmware tab, and it should upgrade them

 

[John14]

Yes, i'm aware of that but on 3cx when going to do the firmware it doesn't show the latest firmware, it just says its updated.

 

[cobaltit]

If it says updated then you are on the latest firmware as far as 3CX is concerned.

 

[complex1]

my current phones version is 28.83.0.50, Yealink T46S, latest firmware is 66.84.0.35

Firmware 28.xx.xx.xx is for T46G and 66.xx.xx.xx is for T46S
You can not use T46G f/w and flash it in the T46S