Upgrade to SP6

[ikonectu]

I just upgraded to SP6. I cannot get the system to register the SN4112 since upgrade.
I have re-generated the config file and imported into SN4112, Upgraded the SN4112 via 3CX. I see calls (via front panel LED) coming into the 4112 but cannot answer (obviously).

When I check port & trunk status I get this message...

 

[craigreilly]

Tried deleting device , readding it and then reconfige rules?
Just a thought...

 

[ikonectu]

Thanks CraigReilly.
That is my "next step". This is my office NFR system. I am a little (a lot) reluctant to upgrade my clients if this is something that could happen to their systems.

Anyone else out there had this experience?

BTW - I really like the new management console. It does appear much faster.