Hey All,
I just did an install at a school and it was brought to my attention after the fact that they use the phones as their intercom system to speak with teachers in each classroom. I installed Fanvil X3U phones in each classroom and the front office will intercom to each room for announcements, etc. I have the speaker volume on each of the phones maxed out but they are saying that the volume is still too low to be able to be heard in a "quiet" classroom.
I just enabled "PBX Delivers Audio" for each of the classroom extensions in the hope that that would boost the volume a bit. I'm waiting to hear from the end users to see if this made any difference. I read that PCMA and PCMU codecs are better for the Fanvil phones, and I have those at the top of the codec list in the PBX.
I am hoping someone out there has done a similar type of install or has an environment similar to this who might be able to make any suggestions on how to increase the intercom volume.
I just did an install at a school and it was brought to my attention after the fact that they use the phones as their intercom system to speak with teachers in each classroom. I installed Fanvil X3U phones in each classroom and the front office will intercom to each room for announcements, etc. I have the speaker volume on each of the phones maxed out but they are saying that the volume is still too low to be able to be heard in a "quiet" classroom.
I just enabled "PBX Delivers Audio" for each of the classroom extensions in the hope that that would boost the volume a bit. I'm waiting to hear from the end users to see if this made any difference. I read that PCMA and PCMU codecs are better for the Fanvil phones, and I have those at the top of the codec list in the PBX.
I am hoping someone out there has done a similar type of install or has an environment similar to this who might be able to make any suggestions on how to increase the intercom volume.
