Configuring Sangoma PRI

[steveh]

Hi,
I'm planning to order a SANGOMA A102 card for the 3cx setup with PSTN.
This card have two PRI ports.
When I start the configuration wizard for the card in "Add PSTN Gateway" i see the option to configure 1 port only.
Does anyone knows if a two port SANGOMA card is supported? if so how do I configure it? do I simply create an addtional VOIP GW for the second port?

Thanks

 

[5qg4]

You status just plan to order a SANGOMA A102 card for the 3cx. If not the budget issue, I would like to suggest you to order Patton SN496X instead. Since most success case are using Patton. And 3CX also recommended Patton as well.

 

[discovery1]

Did you read the 3CX documentation for the supported Sangoma cards?
By the looks of things only the A200 and PRI cards are supported.

http://www.3cx.com/voip-gateways/ - UPDATED LINK

 

[steveh]

Hi,
Looking at 3cx configuration guides they do support Sangoma A101 T1/E1/J1
I don't see the A102 there, this card have two E1 ports.
I need to know if it is supported as well or should I get two A101 cards.
I do have a budget problem so Sangoma card is failry less expensive.

Thanks