DECT base station Yealink W60B will not register

[KraGwort]

We had a working W60B base station with 2 W53H phones. One of the phones dropped and became unregistered. Worked on it for a while with no luck. Then the base station itself dropped to unregistered. Worked on that for a while with no luck. Deleted the base station from the system, reset the base to factory and re-added as a new device/added the provision address given by the system etc.. Confirmed the firmware for both the base and the phones is the latest offered at Yealink. I just cannot get the base to do something it needs to do. This base and phones are still listed as active by 3cx. They are EOL at Yealink. Any suggestions?

 

[TheodorosG_3CX]

Ensure also that you are on the latest firmware version.

 

[JohnS_3CX]

Hi,

The device is indeed EOL but seems to work fine for the time being at least.


I got it working using firmware 77.85.0.180 on 3CX V20 Update 9. Since your system is Hosted by 3CX, you must configure the remote device behind an SBC for it to work (this is mandatory).

Ensure of course that the SBC is indeed online and working, and it's on the same LAN as the W60B.