Yealink W60B Phone provision

[Tyler Oz]

I have been trying to provision our new phones which are W60B. It was way too easy to have our phones provisioned in the old version. I would just plug the phones in then it would pop up. However, now I have to do it myself and it does not work. I have followed the steps on the 3cx page and did the whole process a few times. It still does not work.

 

[SweetAction]

The base is not registered from your screenshots.

Click the auto-provision now button in the webui of the base please.

 

[AWS2P]

As you have always default password to access on GUI DECT Base it's absolutely sure you never provision your W60B

 

[JohnS_3CX]

Step 1 of the guide asks you to upgrade the firmware from a specific site.

Your firmware should be 77.83.0.20 but you have 77.83.0.65 which is neither recommended not tested at this point.

Please take care of this part first so we know we have a good starting point, and then start from scratch using the guide step by step. I can confirm it works fine when doing it this way.
https://www.3cx.com/sip-phones/yealink-dect-w52p/